Land Rover LR3: L319 Discovery 3/4 air suspension corner failure (height sensor, air spring)

The Discovery 3 and 4 (LR3/LR4) use a full air suspension system with corner-specific height sensors, air springs, a compressor, and a valve block. All four corners are independently susceptible to failure. Height sensors develop corrosion and fault at the wiring connector causing the vehicle to incorrectly control ride height. Air springs perish and split (particularly rear springs on high-mileage vehicles). The compressor wears out and the valve block develops leaks. These failures are so prevalent that multiple aftermarket air-to-coil conversion kits exist specifically for this generation. The fault pattern is documented across every major Land Rover owner forum in Australia.

• Vehicle sitting low on one or more corners on startup
• Air suspension warning light or message
• Compressor running continuously attempting to maintain pressure
• Vehicle taking longer than normal to rise from parked height
• Hissing sound from a corner of the vehicle indicating air spring leak

1. 1

   Park the vehicle on flat ground overnight and check it in the morning - a corner that sags overnight indicates a leaking air spring or valve.

2. 2

   Test the full ride-height adjustment cycle through all terrain settings.

3. 3

   Use an IIDTool or compatible scanner to check height sensor readings and suspension fault codes.

4. 4

   Inspect the compressor under the bonnet for signs of overheating or burn marks from running continuously.

Parts involved: Air suspension strut.

≈A$740 to ≈A$3,220 at independent workshop rates, shown as an approximate guide in Australian dollars. That is for this job on its own, not for the car.

An estimate, converted to Australian dollars, for the repair as normally carried out. What a specific car costs depends on which part has failed and what it damaged on the way — treat this as the floor for a negotiation, not a quote.

• “Has the vehicle ever sat low on any corner after being parked overnight?”
• “Has any air suspension warning light appeared?”
• “Have any air springs, height sensors, or the compressor been replaced?”
• “Has the vehicle been converted to coil springs?”

The failure described above is documented in published sources — owner forums, technical service bulletins, recall notices and workshop write-ups — held in our fault database. The inspection instructions and the cost estimate are KickTyres’ own interpretation of them, and it is a starting point for an inspection rather than a manufacturer statement.