MajorCommonTransmission

Nissan Cube: CVT Judder from Degraded Fluid (JF009E / JF011E)

CVT Judder from Degraded Fluid (JF009E / JF011E) is a common transmission fault on the Nissan Cube on the 2002–2019 cars, and we rate it major. Putting it right costs ≈A$2,020 to ≈A$6,440 at independent workshop rates, shown as an approximate guide in Australian dollars. Below is what goes wrong, the symptoms to notice on a test drive, where to look, and what to ask the seller before you hand over any money. It is one of 17 documented faults on the Nissan Cube.

Vehicle: Nissan Cube
Years: 2002–2019
Fuel: petrol
Gearbox: cvt
System: Transmission

This page covers the Nissan Cube as a model. Some faults only affect particular engines or build years — enter a plate below to narrow the list to one car.

All Nissan Cube faults17 documented faults on this model

What you are looking at

No photograph available

We do not hold a verified photograph for this fault yet. We would rather show none than show a picture of something else.

What goes wrong

Cube CVTs use the same JF009E and JF011E units found in Note, Tiida and other Nissan compact platforms. The belt-and-pulley design is sensitive to NS2 fluid condition. JDM-import Cubes in Australia frequently arrive with no CVT service history, causing fluid breakdown and shudder under acceleration. The Z12 Cube CVT is particularly common in Australia's JDM market and shudder complaints are well-documented in both Japanese and Australian Cube forums. Fluid flush at purchase is considered mandatory by import specialists.

What you would notice

Shudder through seat or steering under light throttle at 20–50 km/h
Hesitation or clunk when engaging Drive from Park
Whining or droning under load
Transmission warning light on dash
Slipping or hunting sensation on gradual incline

How to check it

Where to look. CVT transaxle mounted to engine, front of vehicle

Road test at light throttle on level ground between 20–50 km/h. Shudder or vibration is diagnostic. Check CVT fluid colour and condition at service port. Look for records of NS2 fluid change with correct service intervals. Avoid any example with unknown CVT history and visible fluid discolouration.

What it costs to put right

≈A$2,020 to ≈A$6,440 at independent workshop rates, shown as an approximate guide in Australian dollars. That is for this job on its own, not for the car.

An estimate, converted to Australian dollars, for the repair as normally carried out. What a specific car costs depends on which part has failed and what it damaged on the way — treat this as the floor for a negotiation, not a quote.

Ask the seller

“Has the CVT fluid been changed with genuine Nissan NS2 fluid?”
“Has the transmission shuddered or hesitated under normal driving?”
“Is there a CVT service record from Japan or since import?”

Now check the Nissan Cube you are actually looking at

Everything above is true of the model, and it is free. What it does not tell you is whether THIS car still has money owing on it, has been written off or reported stolen, what kms it showed in past sale ads, whether it has had accident repair claims and what it is worth today. That comes from the official records for that plate. Enter the plate and its state for the A$17.90 Vehicle Check, or the full history from A$24.99.

Where this comes from

The failure described above is documented in published sources — owner forums, technical service bulletins, recall notices and workshop write-ups — held in our fault database. The inspection instructions and the cost estimate are KickTyres’ own interpretation of them, and it is a starting point for an inspection rather than a manufacturer statement.

Nissan Cube buyer questions

Is cvt judder from degraded fluid (jf009e / jf011e) serious on a Nissan Cube?

We rate it major and common on the Nissan Cube. Cube CVTs use the same JF009E and JF011E units found in Note, Tiida and other Nissan compact platforms. The belt-and-pulley design is sensitive to NS2 fluid condition. JDM-import Cubes in Australia frequently arrive with no CVT service history, causing fluid breakdown and shudder under acceleration. The Z12 Cube CVT is particularly common in Australia's JDM market and shudder complaints are well-documented in both Japanese and Australian Cube forums. Fluid flush at purchase is considered mandatory by import specialists.

How much does it cost to fix on a Nissan Cube?

≈A$2,020 to ≈A$6,440 at independent workshop rates, shown as an approximate guide in Australian dollars. That figure is for this job on its own. A car showing the symptoms on this page is usually worth either walking away from or negotiating down by at least the repair figure.

Which Nissan Cube years are affected?

Our research records this fault on the 2002–2019 Nissan Cube. Build dates move around, especially on imported cars, so treat the range as the years to look hardest at rather than a guarantee either way. The official records tell you the exact build and first registration date for the car in front of you.