Toyota Hilux: 1KD-FTV Cylinder Head Crack Between Combustion Chambers

The 1KD-FTV 3.0 D-4D cylinder head develops cracks in the fire-deck between adjacent combustion chambers (most commonly between cylinders 2-3 and 3-4). Coolant from the internal galleries migrates into the combustion chamber and is burned off as white exhaust smoke. Toyota Australia acknowledged the fault and ran a Customer Support Programme offering goodwill head replacement for affected vehicles. Prolonged operation accelerates crack propagation and can cause catastrophic overheating or hydrolock.

• Persistent white or grey exhaust smoke under load despite engine at normal temperature
• Unexplained coolant level drop with no visible external leak
• Sweet smell from exhaust and coolant reservoir bubbling under pressure
• Engine overheating events, especially under towing or hill-climbing load

Inspect coolant for brown emulsification. If head is removed, inspect fire-deck with dye-penetrant for hairline cracks between valve bridges. If a workshop inspection is possible: Pressure-test the cooling system cold; observe for combustion gas bubbles in the overflow tank. Remove all glow plugs and perform a block test (combustion gas analyser on coolant cap) to confirm cross-contamination.

Parts involved: Cylinder head.

≈A$3,220 to ≈A$7,820 at independent workshop rates, shown as an approximate guide in Australian dollars. That is for this job on its own, not for the car.

An estimate, converted to Australian dollars, for the repair as normally carried out. What a specific car costs depends on which part has failed and what it damaged on the way — treat this as the floor for a negotiation, not a quote.

• “Has the cylinder head ever been inspected, crack-tested, or replaced?”
• “Has the vehicle been part of the Toyota Customer Support Programme for the 1KD-FTV head?”
• “Is there any history of coolant loss, overheating, or white smoke?”
• “Can you show the last coolant service record and current coolant condition?”

The failure described above is documented in published sources — owner forums, technical service bulletins, recall notices and workshop write-ups — held in our fault database. The inspection instructions and the cost estimate are KickTyres’ own interpretation of them, and it is a starting point for an inspection rather than a manufacturer statement.