Skip to content
MajorCommonEngine

Volvo XC60: Diesel Particulate Filter (DPF) Blockage — D4204T

Diesel Particulate Filter (DPF) Blockage — D4204T is a common engine fault on the Volvo XC60 on the 2010–2017 cars, and we rate it major. Putting it right costs ≈A$460 to ≈A$3,220 at independent workshop rates, shown as an approximate guide in Australian dollars. Below is what goes wrong, the symptoms to notice on a test drive, where to look, and what to ask the seller before you hand over any money. It is one of 20 documented faults on the Volvo XC60.

Vehicle
Volvo XC60
Years
2010–2017
Fuel
diesel
System
Engine

This page covers the Volvo XC60 as a model. Some faults only affect particular engines or build years — enter a plate below to narrow the list to one car.

All Volvo XC60 faults20 documented faults on this model

What you are looking at

No photograph available

We do not hold a verified photograph of the Diesel particulate filter yet. We would rather show none than show a picture of a different part.

What goes wrong

The D4204T diesel in the XC60 is fitted with a diesel particulate filter that requires high-temperature regeneration cycles to burn off accumulated soot. Vehicles used predominantly for short urban trips never reach the exhaust temperature required for passive regeneration, causing the filter to block. Forced active regeneration can clear mild cases; severe blockage requires filter replacement, which is expensive given the unit's location and cost.

What you would notice

  • DPF warning light on dashboard
  • Reduced engine power in limp mode
  • Increased fuel consumption as regeneration cycles run
  • Smell of burning from exhaust during forced regeneration

How to check it

Where to look. Exhaust system underfloor, downstream of catalytic converter

  1. Scan the ECU for DPF soot loading percentage — above 80% indicates imminent blockage.

  2. Ask about the vehicle's typical use: mostly city driving equals high DPF risk.

  3. Check for any history of DPF cleaning or replacement.

  4. On a highway test drive, listen for the engine holding higher revs briefly (active regeneration cycle).

  5. Inspect exhaust tip for excessive sooting.

Parts involved: Diesel particulate filter.

What it costs to put right

≈A$460 to ≈A$3,220 at independent workshop rates, shown as an approximate guide in Australian dollars. That is for this job on its own, not for the car.

An estimate, converted to Australian dollars, for the repair as normally carried out. What a specific car costs depends on which part has failed and what it damaged on the way — treat this as the floor for a negotiation, not a quote.

Ask the seller

  • “Has the DPF warning light ever come on?”
  • “Is the vehicle used mainly for short city trips?”
  • “Has the DPF ever been cleaned or replaced?”

Now check the Volvo XC60 you are actually looking at

Everything above is true of the model, and it is free. What it does not tell you is whether THIS car still has money owing on it, has been written off or reported stolen, what kms it showed in past sale ads, whether it has had accident repair claims and what it is worth today. That comes from the official records for that plate. Enter the plate and its state for the A$17.90 Vehicle Check, or the full history from A$24.99.

Where this comes from

The failure described above is documented in published sources — owner forums, technical service bulletins, recall notices and workshop write-ups — held in our fault database. The inspection instructions and the cost estimate are KickTyres’ own interpretation of them, and it is a starting point for an inspection rather than a manufacturer statement.

Volvo XC60 buyer questions

Is diesel particulate filter (dpf) blockage — d4204t serious on a Volvo XC60?

We rate it major and common on the Volvo XC60. The D4204T diesel in the XC60 is fitted with a diesel particulate filter that requires high-temperature regeneration cycles to burn off accumulated soot. Vehicles used predominantly for short urban trips never reach the exhaust temperature required for passive regeneration, causing the filter to block. Forced active regeneration can clear mild cases; severe blockage requires filter replacement, which is expensive given the unit's location and cost.

How much does it cost to fix on a Volvo XC60?

≈A$460 to ≈A$3,220 at independent workshop rates, shown as an approximate guide in Australian dollars. That figure is for this job on its own. A car showing the symptoms on this page is usually worth either walking away from or negotiating down by at least the repair figure.

Which Volvo XC60 years are affected?

Our research records this fault on the 2010–2017 Volvo XC60. Build dates move around, especially on imported cars, so treat the range as the years to look hardest at rather than a guarantee either way. The official records tell you the exact build and first registration date for the car in front of you.

How do I check for it before I buy?

Scan the ECU for DPF soot loading percentage — above 80% indicates imminent blockage. Ask about the vehicle's typical use: mostly city driving equals high DPF risk. Check for any history of DPF cleaning or replacement. On a highway test drive, listen for the engine holding higher revs briefly (active regeneration cycle). Inspect exhaust tip for excessive sooting. Look here: Exhaust system underfloor, downstream of catalytic converter