Skip to content
MajorCommonFluid Leaks

Holden Commodore: Rear Differential Cover Corrosion & Seal Leak

Rear Differential Cover Corrosion & Seal Leak is a common fluid leaks fault on the Holden Commodore on the 2006–2017 cars, and we rate it major. Putting it right costs ≈A$350 to ≈A$1,290 at independent workshop rates, shown as an approximate guide in Australian dollars. Below is what goes wrong, the symptoms to notice on a test drive, where to look, and what to ask the seller before you hand over any money. It is one of 55 documented faults on the Holden Commodore.

Vehicle
Holden Commodore
Years
2006–2017
Fuel
petrol
System
Fluid Leaks

This page covers the Holden Commodore as a model. Some faults only affect particular engines or build years — enter a plate below to narrow the list to one car.

All Holden Commodore faults55 documented faults on this model

What you are looking at

No photograph available

We do not hold a verified photograph of the Differential or Body corrosion yet. We would rather show none than show a picture of a different part.

What goes wrong

The VE and VF Commodore use a Salisbury-type rear differential with a stamped steel rear cover sealed by a gasket. In Australian coastal and high-rainfall environments the rear cover corrodes from the outside-in, thinning the metal at the gasket flange. The pinion seal and axle shaft seals also degrade from age and heat cycling. As the rear cover corrodes, the gasket cannot maintain a seal against the pitted flange surface, allowing gear oil to seep and eventually drip from the rear of the differential housing. Low differential oil causes premature bearing and hypoid gear wear. In severe cases the cover perforates, resulting in sudden fluid loss and differential failure. V8 and manual-transmission variants with limited-slip differentials are more susceptible due to higher operating temperatures from aggressive use.

What you would notice

  • Oil drips or staining on the driveway beneath the rear differential
  • Gear oil smell after driving, particularly noticeable after the diff has warmed up
  • Rust staining and discolouration on the rear face of the differential cover
  • Whining or howling from the rear axle at speed if oil level has dropped significantly
  • Visible wet seepage around the axle shaft seal where it meets the differential housing

How to check it

Where to look. Rear differential housing at the rear axle, centre of the rear subframe; the cover is the rearmost face of the differential unit facing the ground

  1. Get beneath the rear of the vehicle and inspect the rear differential cover for rust, pitting, and wet oil seepage around the cover gasket seam.

  2. Run a finger along the bottom of the diff cover — tacky or wet surfaces indicate an active leak.

  3. Check both axle shaft seals where the shafts exit the housing.

  4. Inspect the pinion seal at the front of the diff where the tailshaft connects.

  5. If there is heavy surface rust on the cover, probe it for soft or perforated spots.

Parts involved: Differential, Body corrosion.

What it costs to put right

≈A$350 to ≈A$1,290 at independent workshop rates, shown as an approximate guide in Australian dollars. That is for this job on its own, not for the car.

An estimate, converted to Australian dollars, for the repair as normally carried out. What a specific car costs depends on which part has failed and what it damaged on the way — treat this as the floor for a negotiation, not a quote.

Ask the seller

  • “When was the differential oil last changed, and what fluid is in it?”
  • “Has any oil leak from the rear differential been noticed or repaired?”
  • “Has the differential cover or pinion seal ever been replaced?”
  • “Is this vehicle used in coastal or high-salt-exposure areas?”

Now check the Holden Commodore you are actually looking at

Everything above is true of the model, and it is free. What it does not tell you is whether THIS car still has money owing on it, has been written off or reported stolen, what kms it showed in past sale ads, whether it has had accident repair claims and what it is worth today. That comes from the official records for that plate. Enter the plate and its state for the A$17.90 Vehicle Check, or the full history from A$24.99.

Where this comes from

The failure described above is documented in published sources — owner forums, technical service bulletins, recall notices and workshop write-ups — held in our fault database. The inspection instructions and the cost estimate are KickTyres’ own interpretation of them, and it is a starting point for an inspection rather than a manufacturer statement.

Holden Commodore buyer questions

Is rear differential cover corrosion & seal leak serious on a Holden Commodore?

We rate it major and common on the Holden Commodore. The VE and VF Commodore use a Salisbury-type rear differential with a stamped steel rear cover sealed by a gasket. In Australian coastal and high-rainfall environments the rear cover corrodes from the outside-in, thinning the metal at the gasket flange. The pinion seal and axle shaft seals also degrade from age and heat cycling. As the rear cover corrodes, the gasket cannot maintain a seal against the pitted flange surface, allowing gear oil to seep and eventually drip from the rear of the differential housing. Low differential oil causes premature bearing and hypoid gear wear. In severe cases the cover perforates, resulting in sudden fluid loss and differential failure. V8 and manual-transmission variants with limited-slip differentials are more susceptible due to higher operating temperatures from aggressive use.

How much does it cost to fix on a Holden Commodore?

≈A$350 to ≈A$1,290 at independent workshop rates, shown as an approximate guide in Australian dollars. That figure is for this job on its own. A car showing the symptoms on this page is usually worth either walking away from or negotiating down by at least the repair figure.

Which Holden Commodore years are affected?

Our research records this fault on the 2006–2017 Holden Commodore. Build dates move around, especially on imported cars, so treat the range as the years to look hardest at rather than a guarantee either way. The official records tell you the exact build and first registration date for the car in front of you.

How do I check for it before I buy?

Get beneath the rear of the vehicle and inspect the rear differential cover for rust, pitting, and wet oil seepage around the cover gasket seam. Run a finger along the bottom of the diff cover — tacky or wet surfaces indicate an active leak. Check both axle shaft seals where the shafts exit the housing. Inspect the pinion seal at the front of the diff where the tailshaft connects. If there is heavy surface rust on the cover, probe it for soft or perforated spots. Look here: Rear differential housing at the rear axle, centre of the rear subframe; the cover is the rearmost face of the differential unit facing the ground