Skip to content
MajorCommonEngine

Nissan Skyline: VR30DDTT Valve Stem Seal Oil Consumption

VR30DDTT Valve Stem Seal Oil Consumption is a common engine fault on the Nissan Skyline on the 2019–2023 cars, and we rate it major. Putting it right costs ≈A$1,660 to ≈A$3,860 at independent workshop rates, shown as an approximate guide in Australian dollars. Below is what goes wrong, the symptoms to notice on a test drive, where to look, and what to ask the seller before you hand over any money. It is one of 42 documented faults on the Nissan Skyline.

Vehicle
Nissan Skyline
Only on
Bi-Turbo / twin-turbo
Engine
VR30-DDTT
Years
2019–2023
Fuel
petrol
Gearbox
auto
System
Engine

This page covers the Nissan Skyline as a model. Some faults only affect particular engines or build years — enter a plate below to narrow the list to one car.

All Nissan Skyline faults42 documented faults on this model

What you are looking at

No photograph available

We do not hold a verified photograph of the Catalytic converter or Turbocharger yet. We would rather show none than show a picture of a different part.

What goes wrong

The VR30DDTT twin-turbo 3.0-litre engine suffers from accelerated valve stem seal degradation, causing engine oil to be drawn past the seals into the combustion chamber during deceleration and cold starts. Affected engines can consume 0.5–1 litre per 1,000 km well before service intervals, with blue smoke typically visible on cold morning starts and on overrun. Nissan issued TSB NTB18-043 addressing oil consumption on this engine family. The root cause is premature hardening and wear of the valve stem seals, exacerbated by high under-bonnet temperatures from the twin-turbo configuration. Left unaddressed, catalytic converter fouling and spark plug fouling follow.

What you would notice

  • Blue-grey smoke from exhaust on cold start that clears after warm-up
  • Blue smoke puff from tailpipe on sharp throttle lift-off or engine braking
  • Oil level drops noticeably between service intervals with no external leaks
  • Fouled spark plugs with oil deposits on electrode
  • Catalytic converter smell or early converter failure due to oil contamination

How to check it

Where to look. Cylinder head valve stems, both banks of VR30DDTT engine

  1. Check the engine oil level against the service record interval and ask owner how often oil is topped up.

  2. Start the engine cold and watch exhaust for blue smoke.

  3. Rev the engine to 3000 rpm then lift off sharply and observe tailpipe for puff of blue smoke on overrun.

  4. Inspect the spark plugs for oil fouling if accessible.

  5. Request any dealer oil consumption test documentation.

Parts involved: Catalytic converter, Turbocharger.

What it costs to put right

≈A$1,660 to ≈A$3,860 at independent workshop rates, shown as an approximate guide in Australian dollars. That is for this job on its own, not for the car.

An estimate, converted to Australian dollars, for the repair as normally carried out. What a specific car costs depends on which part has failed and what it damaged on the way — treat this as the floor for a negotiation, not a quote.

Ask the seller

  • “How many litres of oil have you added between the last two services, and what is the mileage between those services?”
  • “Has Nissan or a dealer performed an oil consumption test under TSB NTB18-043, and what was the result?”
  • “Is there any history of spark plug replacement due to oil fouling?”

Now check the Nissan Skyline you are actually looking at

Everything above is true of the model, and it is free. What it does not tell you is whether THIS car still has money owing on it, has been written off or reported stolen, what kms it showed in past sale ads, whether it has had accident repair claims and what it is worth today. That comes from the official records for that plate. Enter the plate and its state for the A$17.90 Vehicle Check, or the full history from A$24.99.

Where this comes from

The failure described above is documented in published sources — owner forums, technical service bulletins, recall notices and workshop write-ups — held in our fault database. The inspection instructions and the cost estimate are KickTyres’ own interpretation of them, and it is a starting point for an inspection rather than a manufacturer statement.

Nissan Skyline buyer questions

Is vr30ddtt valve stem seal oil consumption serious on a Nissan Skyline?

We rate it major and common on the Nissan Skyline. The VR30DDTT twin-turbo 3.0-litre engine suffers from accelerated valve stem seal degradation, causing engine oil to be drawn past the seals into the combustion chamber during deceleration and cold starts. Affected engines can consume 0.5–1 litre per 1,000 km well before service intervals, with blue smoke typically visible on cold morning starts and on overrun. Nissan issued TSB NTB18-043 addressing oil consumption on this engine family. The root cause is premature hardening and wear of the valve stem seals, exacerbated by high under-bonnet temperatures from the twin-turbo configuration. Left unaddressed, catalytic converter fouling and spark plug fouling follow.

How much does it cost to fix on a Nissan Skyline?

≈A$1,660 to ≈A$3,860 at independent workshop rates, shown as an approximate guide in Australian dollars. That figure is for this job on its own. A car showing the symptoms on this page is usually worth either walking away from or negotiating down by at least the repair figure.

Which Nissan Skyline years are affected?

Our research records this fault on the 2019–2023 Nissan Skyline. Build dates move around, especially on imported cars, so treat the range as the years to look hardest at rather than a guarantee either way. The official records tell you the exact build and first registration date for the car in front of you.

How do I check for it before I buy?

Check the engine oil level against the service record interval and ask owner how often oil is topped up. Start the engine cold and watch exhaust for blue smoke. Rev the engine to 3000 rpm then lift off sharply and observe tailpipe for puff of blue smoke on overrun. Inspect the spark plugs for oil fouling if accessible. Request any dealer oil consumption test documentation. Look here: Cylinder head valve stems, both banks of VR30DDTT engine