Subaru Forester: EJ20 Water Pump Plastic Impeller Wear
EJ20 Water Pump Plastic Impeller Wear is a common cooling fault on the Subaru Forester on the 1997–2002 cars, and we rate it critical. Putting it right costs ≈A$370 to ≈A$830 at independent workshop rates, shown as an approximate guide in Australian dollars. Below is what goes wrong, the symptoms to notice on a test drive, where to look, and what to ask the seller before you hand over any money. It is one of 53 documented faults on the Subaru Forester.
- Vehicle
- Subaru Forester
- Engine
- EJ20
- Years
- 1997–2002
- Fuel
- petrol
- System
- Cooling
What you are looking at
No photograph available
What goes wrong
The EJ20 water pump uses a plastic impeller that degrades over time, shedding material and eventually spinning freely on the shaft with no coolant flow. Failure causes sudden overheating with no prior warning. The pump is driven by the timing belt, so replacement is typically done concurrently with timing belt service. Documented extensively on Subaru enthusiast forums and by Australian mechanics as a near-inevitable service item on high-kilometre SF Foresters.
What you would notice
- Sudden overheating with no visible coolant leak
- Coolant temperature rising rapidly under load
- No heat from heater despite engine reaching operating temperature
- Coolant flow absent when cap removed at idle (technician check)
How to check it
Where to look. Front of EJ20 engine, driven by timing belt
Confirm timing belt service history; check whether water pump was replaced at the same time; inspect coolant colour for impeller debris; request workshop check of impeller integrity if history is unknown.
What it costs to put right
≈A$370 to ≈A$830 at independent workshop rates, shown as an approximate guide in Australian dollars. That is for this job on its own, not for the car.
Ask the seller
- “When was the timing belt last replaced and was the water pump done at the same time?”
- “Has the car ever overheated?”
Now check the Subaru Forester you are actually looking at
Everything above is true of the model, and it is free. What it does not tell you is whether THIS car still has money owing on it, has been written off or reported stolen, what kms it showed in past sale ads, whether it has had accident repair claims and what it is worth today. That comes from the official records for that plate. Enter the plate and its state for the A$17.90 Vehicle Check, or the full history from A$24.99.
Where this comes from
Subaru Forester buyer questions
Is ej20 water pump plastic impeller wear serious on a Subaru Forester?
We rate it critical and common on the Subaru Forester. The EJ20 water pump uses a plastic impeller that degrades over time, shedding material and eventually spinning freely on the shaft with no coolant flow. Failure causes sudden overheating with no prior warning. The pump is driven by the timing belt, so replacement is typically done concurrently with timing belt service. Documented extensively on Subaru enthusiast forums and by Australian mechanics as a near-inevitable service item on high-kilometre SF Foresters.
How much does it cost to fix on a Subaru Forester?
≈A$370 to ≈A$830 at independent workshop rates, shown as an approximate guide in Australian dollars. That figure is for this job on its own. A car showing the symptoms on this page is usually worth either walking away from or negotiating down by at least the repair figure.
Which Subaru Forester years are affected?
Our research records this fault on the 1997–2002 Subaru Forester. Build dates move around, especially on imported cars, so treat the range as the years to look hardest at rather than a guarantee either way. The official records tell you the exact build and first registration date for the car in front of you.
How do I check for it before I buy?
Confirm timing belt service history; check whether water pump was replaced at the same time; inspect coolant colour for impeller debris; request workshop check of impeller integrity if history is unknown. Look here: Front of EJ20 engine, driven by timing belt