Skip to content
KickTyres
Toyota2002–2007 Major issues documented

Toyota Urban Cruiser XP60: common faults & what to check

The XP60 is the Toyota Urban Cruiser built 2002–2007. Of the 7 faults documented for the Urban Cruiser, 7 apply to this generation, each with its symptoms, what to inspect and a typical repair cost. Free, no account needed.

Check this exact Toyota Urban Cruiser

  • Odometer history
  • Money owing
  • Reported stolen
  • Ownership history
  • Official NZ vehicle register data
  • NZ owned and operated

Type the plate for the free basics. The full record is a paid check from $13.49, one car at a time, no subscription.

No NZ plate yet, or buying in Australia? Pick the generation and engine and start a free check below. New to KickTyres? How the check works →

7

Documented faults

Major

Most serious

$250–$600

Typical repair

5

Systems covered

You're looking at the XP60

Everything below is narrowed to this variant. Pick a different one to change it.

Choose a different generation

Now narrow it to the engine

A 1.8 and a 2.4 of the same car do not fail the same way, so the faults below narrow to the engine as well as the year. Free, no account needed.

Which engine is in it? These cover every year of this model.

1.5L petrol (1NZ-FE)· 1.5 litre petrol

A 2002 Toyota Urban Cruiser is the XP60 generation (2002 to 2007).

We cannot narrow the engine list to this year, so every engine this model was sold with is offered.

Start your free check on this Toyota Urban Cruiser

No plate needed. You get the risk score, the buyer's checklist and the guided inspection for the exact car you picked above — not the whole nameplate.

Toyota Urban Cruiser XP60

Free. The paid plate check is separate, and stays optional.

Can't confirm for this car

Toyota Urban Cruiser · 2002

Narrowed to the year. No engine is recorded for this vehicle. Pick an engine to see which faults apply.

Tell us the engine, or check the engine code on the car, before relying on this.

  • No engine is recorded for this vehicle.

matched on year only

What to look out for

The checks worth doing on a Toyota Urban Cruiser before you hand over any money. Every documented fault is listed below, each with its own page.

  • Costly issue

    Check for pulling under braking.

    See why

    Brake Caliper Guide Pin Seizure

    Front brake caliper guide pins seize from corrosion causing uneven pad wear.

    What you would notice

    • Vehicle pulling to one side under braking
    • One front disc hotter than the other after moderate use

    Typically $150–$500 to put right.

  • Costly issue

    Scan for EPS fault codes.

    See why

    Electric Power Steering Failure

    The NCP60 Ist electric power steering column motor can fail causing a sudden or gradual loss of power assistance. The failure is typically accompanied by an EPS warning light on the instrument cluster. Affected vehicles require significant steering effort especially during low-speed manoeuvring and parking, and replacement of the EPS column unit is the usual repair.

    What you would notice

    • Sudden loss of power steering with EPS warning light
    • Heavy steering requiring effort especially at low speeds

    Typically $600–$2,000 to put right.

  • Common issue

    Inspect rear beam mounting bushes for cracking.

    See why

    Rear Torsion Beam Bush Collapse

    Rear beam axle rubber bushes harden and collapse causing rear knocking and imprecision.

    What you would notice

    • Knocking from rear suspension over rough surfaces
    • Imprecise rear handling feel

    Typically $200–$550 to put right.

  • Common issue

    Inspect throttle body bore for carbon deposits.

    See why

    Throttle Body Carbon Fouling

    Throttle body butterfly and bore accumulate carbon from crankcase vapour causing rough idle and hesitation.

    What you would notice

    • Rough idle and hesitation from rest at light throttle
    • Occasional stalling when releasing throttle in traffic

    Typically $80–$300 to put right.

See all 7 issues for this oneDocumented for the exact year and engine you picked.
Engine, transmission & cooling1

01Throttle Body Carbon Fouling

Inspect throttle body bore for carbon deposits.petrol2002–2007Engine
CommonEngine $80–$300 to fix

Throttle body butterfly and bore accumulate carbon from crankcase vapour causing rough idle and hesitation.

Symptoms to notice

  • Rough idle and hesitation from rest at light throttle
  • Occasional stalling when releasing throttle in traffic

What to check

  1. Inspect throttle body bore for carbon deposits.
  2. Note rough idle quality and hesitation on deceleration.

Where to look: Throttle body on intake manifold

Ask the seller

  • “Has the throttle body carbon fouling been inspected or repaired?”
Electrical1

02Electric Power Steering Failure

Scan for EPS fault codes.2002–2007Electrical
OccasionalElectrical $600–$2,000 to fix

The NCP60 Ist electric power steering column motor can fail causing a sudden or gradual loss of power assistance. The failure is typically accompanied by an EPS warning light on the instrument cluster. Affected vehicles require significant steering effort especially during low-speed manoeuvring and parking, and replacement of the EPS column unit is the usual repair.

Symptoms to notice

  • Sudden loss of power steering with EPS warning light
  • Heavy steering requiring effort especially at low speeds

What to check

  1. Scan for EPS fault codes.
  2. Test steering — any heavy feel warrants investigation.

Where to look: EPS column motor and control unit

Parts involved: Steering rack.

Ask the seller

  • “Has the electric power steering failure been inspected or repaired?”
Body, brakes, suspension & interior3

03Brake Caliper Guide Pin Seizure

Check for pulling under braking.2002–2007Brakes
CommonBrakes $150–$500 to fix

Front brake caliper guide pins seize from corrosion causing uneven pad wear.

Symptoms to notice

  • Vehicle pulling to one side under braking
  • One front disc hotter than the other after moderate use

What to check

  1. Check for pulling under braking.
  2. Feel for uneven wheel heat.
  3. Inspect guide pins.

Where to look: Front brake calipers

Parts involved: Brake disc and pads.

Ask the seller

  • “Has the brake caliper guide pin seizure been inspected or repaired?”

04Front Strut Top Mount Bearing Clunking

Front strut top mount bearings wear causing clunking when turning the steering wheel and over bumps.2002–2007Suspension
CommonSuspension $250–$600 to fix

Front strut top mount bearings wear causing clunking when turning the steering wheel and over bumps. Very common on urban-use Ist examples.

Symptoms to notice

  • Clunking from front struts when turning or going over bumps
  • Clunking that is directionally repeatable at the same point in steering travel

What to check

Turn the steering wheel slowly from lock to lock with vehicle stationary — clunking that repeats at the same steering angle indicates worn top mount bearings.

Where to look: Front strut top mount bearings both sides

Parts involved: Shock absorber / strut.

Ask the seller

  • “Has the front strut top mount bearing been inspected or repaired?”

05Rear Torsion Beam Bush Collapse

Inspect rear beam mounting bushes for cracking.2002–2007Suspension
CommonSuspension $200–$550 to fix

Rear beam axle rubber bushes harden and collapse causing rear knocking and imprecision.

Symptoms to notice

  • Knocking from rear suspension over rough surfaces
  • Imprecise rear handling feel

What to check

  1. Inspect rear beam mounting bushes for cracking.
  2. Push beam laterally — any movement indicates collapsed bushes.

Where to look: Rear beam axle mounting points

Ask the seller

  • “Has the rear torsion beam bush collapse been inspected or repaired?”
Depends on the exact engine — 2 moreDocumented for a specific engine we could not confirm from what you picked. Check the engine code on the car.
Engine, transmission & cooling2

011NZ-FE Timing Chain Tensioner Cold-Start Rattle

Cold-start from overnight cold and listen for rattle from engine front.petrol2002–2007Engine
CommonEngine $600–$1,800 to fix

Can't confirm for this car

The 1NZ-FE timing chain tensioner rattles on cold start. Common at 80,000+ km. Extended rattle indicates worn tensioner.

The front of a dual overhead camshaft engine with the timing cover removed, exposing the timing chain and sprockets.Example of the part — not this vehicle

The front of a twin-cam engine with the timing cover off — chain, sprockets and guides.

Logansenf · CC BY-SA 4.0 · Wikimedia Commons

Symptoms to notice

  • Metallic rattle from engine front on cold start
  • Rattle persisting beyond 10 seconds or at operating temperature

What to check

Cold-start from overnight cold and listen for rattle from engine front. Normal: clears in under 5 seconds.

Where to look: Front of engine, timing chain tensioner

Parts involved: Timing chain.

Ask the seller

  • “Has the 1nz-fe timing chain tensioner cold-start been inspected or repaired?”

02K110 CVT Belt Judder on Take-Off

Test drive and feel for vibration during light acceleration from rest.petrol2002–2007Transmission
Very commonTransmission $600–$3,500 to fix

Can't confirm for this car

The Ist K110 CVT develops shudder from belt and pulley wear on urban-use examples. Toyota CVTF FE specification must be used.

Symptoms to notice

  • Rhythmic shudder or buzz from drivetrain during light acceleration from rest
  • CVT fluid darker than the correct clear pink

What to check

Test drive and feel for vibration during light acceleration from rest. CVT fluid darker than the correct pink indicates degraded fluid.

Where to look: CVT gearbox in engine bay

Parts involved: CVT belt and pulleys.

Ask the seller

  • “Has the k110 cvt belt judder on been inspected or repaired?”

What these repairs cost on other cars

Some of the Toyota Urban Cruiser’s documented faults are repairs other models share. Each page lists the documented NZ cost for every model it affects.

Other Toyota models

Toyota Prado64 documented faultsToyota RAV463 documented faultsToyota Hilux59 documented faultsToyota Aurion6 documented faultsToyota Corolla Spacio6 documented faultsToyota Cresta6 documented faults

Toyota Urban Cruiser buyer questions

Is the Toyota Urban Cruiser reliable?

Like any used car, it depends on the specific example and its service history. Across the 7 documented faults for the Toyota Urban Cruiser, the recurring problem areas are transmission, electrical, and engine. A Toyota Urban Cruiser with a full service history and no signs of the issues listed on this page can be a sound buy but each one needs to be checked individually before you commit.

What are the most common problems with a used Toyota Urban Cruiser?

We've catalogued 7 known faults for the Toyota Urban Cruiser, covering transmission, electrical, and engine. All 7 are written out in full on this page, with the symptoms to notice, what to inspect, and typical repair costs for each. Free to read, no account needed.

How much do repairs cost on a Toyota Urban Cruiser?

Most single repairs on the Toyota Urban Cruiser fall between $250–$600 at NZ independent-workshop rates. Some of the 7 documented faults cost less and a few cost considerably more, and no one car needs them all. Knowing which ones to look for before you view is what lets you negotiate the price down or walk away.

Should I get a pre-purchase inspection on a Toyota Urban Cruiser?

Yes. A Toyota Urban Cruiser inspection focused on its known weak points is the single best way to avoid an expensive mistake. KickTyres gives you a guided, model-specific inspection plus a market valuation and negotiation figure for $24.90 far less than the cost of missing one of the faults on this page.